Commander 147

[mbd]

Ditto that. Good to hear from you Jerry.

[Commander 147]

Thanks Ben, Tony and Mike

I have some serious catching up to do here since I have not even peeked in for a while.

The deck recore on the starboard side was simialr in scope to the port side but differant in location. On the bow I had a section on the starboard side that was mush. The side decks were not as bad however so the amount of work was similar. A few pictures below.

[Commander 147]

I've been enjoying the cooler temps lately and getting a little more work done on Destiny. I finally got around to making the new coaming boards for Destiny and the very complicated to construct transition pieces that tie the coaming boards into the cabin sides. I still have some rounding over of edges and fine tuning to do but I want to take them off again before I do that and before I take them off I need to modify the winch stands so they fit perfectly where I want them.

I had so many parts and pieces in the shop the place was getting cluttered so I started installing some to get them out of the way. I have blue painter's tape covering the light gray countertops to protect them from scratches I would have to sand out.